Tech Support

I want to go from wet to dry in the blast pot.

  1. Blast all media and water out of machine.

  2. Remove fill cap.

  3. Turn on air coolers and dryers.

  4. Open air inlet valve halfway and let air circulate through machine for 5-7 min or until completely dry.

  5. Put fill cap back on machine and pressurize tank.

  6. Run air through the machine just like you were blasting for 2-3 min.

  7. Shine light in machine to be sure all moisture is gone from the bottom.

  8. If no moisture, fill with 1 bag of dry abrasive. Be sure there are no issues, and then fill the remainder of the way.

 
Didn't solve your problem? Look at answers to some common issues here or contact us at 713-869-2227.